<< Previous Page (What are Detection Limits?)

Why should I care about reporting limits?

It is common for commercial analytical laboratories to have reporting limits that are above the concentration you are interested in seeing down to. For example, if you are testing water samples for vinyl chloride and are concerned about meeting a regulatory limit of 0.5 µg/L, then you will want to make sure the analytical laboratory has reporting limits below 0.5 µg/L. This way, you will be able to see whether a concentration of vinyl chloride detected in your sample is above the regulatory limit of concern.

On the other hand, if your reporting limit is above a regulatory limit, say 1.0 µg/L in this example, it may be possible that your sample is contaminated to a level above the regulatory limit, but you would never know it. For example, it is possible that 1) the regulatory limit you are concerned about is 0.5 µg/L, 2) your sample actually contains a concentration of 0.7 µg/L, and 3) your analytical laboratory has a reporting limit of 10 µg/L. In this case, the laboratory report will read Non-Detect which may lead you to conclude your sample is clean only to find out later that the groundwater beneath your site is above regulatory limits. This may happen because a future investigator comes along using lower reporting limits that do not mask the detection of contaminants. This detail may end up costing tens or hundreds of thousands of dollars, particularly on large sampling programs where hundreds of samples are being analyzed.

How do I make sure I get the right reporting limits?

It is important to specify what reporting limits you need for each chemical your analytical laboratory will test for you before you order your analyses. The best place for this is in your purchase order or contract with the analytical laboratory. It is not uncommon for a laboratory to test for a suite of similar chemical compounds and to use the same reporting limit for all the compounds in the suite. However, this may not be sufficient for your needs if you are concerned about very low regulatory limits for one of chemicals in this suite. If you specify what reporting limits you need, the laboratory may be able to pick a more appropriate analysis method to suit your needs.